Posted By: Bob_Coomer
O-ring blocks and heads questions - 09/24/11 04:13 AM
What if a cylinder head has a O-ring receiver groove machined into the heads, and your not going that route. I know decking will take care of it, but what if you dont want to deck out the groove?
The block will not have the groove in this case. I dont see how it can effect the seal as long as the O-ring is inside or even out side the head gasket fire ring?
The block will not have the groove in this case. I dont see how it can effect the seal as long as the O-ring is inside or even out side the head gasket fire ring?