Posted By: Joesixpack
Up close and personal with a Pro Stock Engine! - 06/27/11 11:37 PM
going way back for this one,had a #1 on the car if that tells you anything....
![6702723-Scan8_0008.jpg Attached picture 6702723-Scan8_0008.jpg](https://board.moparts.org/ubbthreads/upload2/6702723-Scan8_0008.jpg)
![6702723-Scan8_0008.jpg Attached picture 6702723-Scan8_0008.jpg](https://board.moparts.org/ubbthreads/upload2/6702723-Scan8_0008.jpg)
Quote:Yep, worked good! So did the furnace belt, 5/16 clear rubber!
I like the blower motor running the water pump. As this is what i used for years.lol![]()
Quote:
Hmmmm, rubber fuel line to the carbs and brass push on fittings on the "junk" Holley regulators. Too funny! Although, the Holley was the only regulator out there at that time wasn't it?
Wonder what those 2 little deals seemingly wrapped in duct tape are...the shapes of fuel filters...
When you look back, it's amazing how much power those guys got out of small blocks, iron heads and cast intakes!![]()
Quote:
Hmmmm, rubber fuel line to the carbs and brass push on fittings on the "junk" Holley regulators. Too funny! Although, the Holley was the only regulator out there at that time wasn't it?
Wonder what those 2 little deals seemingly wrapped in duct tape are...the shapes of fuel filters...
When you look back, it's amazing how much power those guys got out of small blocks, iron heads and cast intakes!![]()