Posted By: D-50
Indy heads - 04/20/11 02:52 AM
I am thinking about buying a set of ported 360-2 heads and intake for a 420 small block that I plan on building this fall. Right now I am running a 360/380 hp crate motor in my D-50.Do you think these heads would work very well if I put them on my crate motor while I was collecting the parts for the other motor.It would be hard to let the heads just set in the closet for a few months.
Posted By: Wedgeman
Re: Indy heads - 04/20/11 04:34 AM
have a look at the current c.r. and the one it would yield with the -2 heads
Don't forget you would need the matching intake and valve train
Dan
Posted By: fishy340
Re: Indy heads - 04/20/11 09:52 PM
u never know,my bud switched from a set of worked eddy's to a set of 360-1's and dropped a 1/2 sec with no other change then the headers and heads,,on a race motor
Tough to say, on a race only deal where bottom end doesn't matter too much it might not be too bad. I've thought about trying it as well but never have.
Posted By: D-50
Re: Indy heads - 04/21/11 10:59 PM
They are CNC ported 360-2 230cc and ported 360-3 intake.I am buying them from a moparts member.
Posted By: Just-a-dart
Re: Indy heads - 04/23/11 06:17 PM
Hi D-50. Looks like a fun truck. I run Indy 360-1s on my car,they are not a quick bolt on for your truck. Different exhaust port, Rocker oiling, push rods,etc. I think you would be better off to wait and put them on your big motor. The Indys do make power but you have to check everything, and don't believe the book specs. Also I would never ever ever ever buy another kit from Indy, heads and intake only. Have fun with it.