{{{ PLAIN CAST SMALL BLOCK VALVE COVERS...???? }}}

{{{ PLAIN CAST SMALL BLOCK VALVE COVERS...???? }}} - 08/03/10 09:48 PM

Cannot find a plain (no raised lettering) set of die-cast valve covers (not fabricated) for a small block mopar anywhere....in fact can't find a set even with raised letters that could be milled off

Anyone know of a source...?????????

Thanks

Rickster

Posted By: 9 Sec Phill

Re: {{{ PLAIN CAST SMALL BLOCK VALVE COVERS...???? }}} - 08/03/10 10:04 PM

Thought summit sold them, there name on the top just had to be milled off...Ask Dragula

Posted By: rickstershemi

Re: {{{ PLAIN CAST SMALL BLOCK VALVE COVERS...???? }}} - 08/03/10 10:06 PM

Quote:

Thought summit sold them, there name on the top just had to be milled off...Ask Dragula

They used to but no more, already talked to them on it...

Rickster

Posted By: BigEdsGarage

Re: {{{ PLAIN CAST SMALL BLOCK VALVE COVERS...???? }}} - 08/04/10 09:35 PM

I just milled the ribs off the MP ones but kept the logo. Would have been easy to just mill them clean though.

Posted By: rickstershemi

Re: {{{ PLAIN CAST SMALL BLOCK VALVE COVERS...???? }}} - 08/04/10 11:01 PM

Quote:

I just milled the ribs off the MP ones but kept the logo. Would have been easy to just mill them clean though.

Ed....Thank You, that is an awesome idea, sure never crossed my mind and you did an awesome job....that baby is clean

Rickster

Posted By: Adobedude

Re: {{{ PLAIN CAST SMALL BLOCK VALVE COVERS...???? }}} - 08/05/10 02:19 AM

Quote:

I just milled the ribs off the MP ones but kept the logo. Would have been easy to just mill them clean though.

Nice...I have a pair of Covers I was going to mill smooth, never thought about leaving the logo.