Thanks SAM at TTI !!!!!

I bought a set of TTI headders off of here. W5 coated headers that were isted as an A body set. They are for an E body. I have them in the car, they hit a few spots, and I found that the only differance is the #7 tube. For $30 Sam at TTI bent me the #7 tube, and shipped it to me. I just have to Fab them into place.

Does anyone here have a picture of the drivers side of of 1 7/8" A body TTI set?

I know how its supposed to be, but it might be a little easier with a picture to go off of.

Kasey

Here is what I have going on so far. Im gonna have some more modifications coming up with the fact that I had to make 3/8 spacers on each side for adapters. So I have a little bit of torsion bar clearance issues.

Kasey

width issues

Another shot.

Im gonna gave to move the second pipe already welded on inn twords the block to clear the torsion bar.

Shouldnt be too bad.

Kasey

I dont think they will fit, so more hacking, and fitting after engine is in.

Not too terribly worried, Starting with really good headers.

Shame to cut up TTI headers, but they are going good.

Kasey