Posted By: flatiron
Evac nipple location - 06/06/10 04:54 PM
How far from the end of the header do you weld the nipple for a evac setup
Evac nipple location
Posted By: Crizila
Re: Evac nipple location - 06/06/10 10:08 PM
Most want it located right after the 4 in to 1 junction area.
Posted By: MR_P_BODY
Re: Evac nipple location - 06/06/10 10:43 PM
Put the end of the nipple about 3" past the end of the
primary tubes IF you dont run a O2 sensor.... O2 sensor
should be UP stream of the evac
primary tubes IF you dont run a O2 sensor.... O2 sensor
should be UP stream of the evac
Posted By: flatiron
Re: Evac nipple location - 06/06/10 11:38 PM
Ok headers are already on car and welding the nipple in on top of collector will be a job. Would it matter if I welded them on the side say at 3 and 9 oclock postions
Posted By: chryco
Re: Evac nipple location - 06/06/10 11:45 PM
It won`t matter.............
Posted By: Crizila
Re: Evac nipple location - 06/06/10 11:51 PM
Don't know that it makes a difference circumference wise. The Moroso instructions show them mounted in the crevice ( and there are 4 to choose from )of the collector just aft of the 4 in to 1 junction at 45 degree angle. Assume they consider that a low pressure area on most headers.
Posted By: MR_P_BODY
Re: Evac nipple location - 06/07/10 12:22 AM
Quote:
Ok headers are already on car and welding the nipple in on top of collector will be a job. Would it matter if I welded them on the side say at 3 and 9 oclock postions
Where did you get the idea of 12 o clock the sides are
fine
Posted By: flatiron
Re: Evac nipple location - 06/07/10 04:01 AM
Quote:Seems like most of the ones I seen the nipple was on topQuote:
Ok headers are already on car and welding the nipple in on top of collector will be a job. Would it matter if I welded them on the side say at 3 and 9 oclock postions
Where did you get the idea of 12 o clock the sides are
fine
Posted By: tubtar
Re: Evac nipple location - 06/07/10 05:50 AM
If you are going to try inside , make real sure that the transmission won't interfere too.
Don't ask me how I know that one.
Mocking up outside the car ain't all it's cracked up to be.
Don't ask me how I know that one.
Mocking up outside the car ain't all it's cracked up to be.
Posted By: MR_P_BODY
Re: Evac nipple location - 06/07/10 11:34 AM
Quote:Quote:Seems like most of the ones I seen the nipple was on topQuote:
Ok headers are already on car and welding the nipple in on top of collector will be a job. Would it matter if I welded them on the side say at 3 and 9 oclock postions
Where did you get the idea of 12 o clock the sides are
fine
I have never seen them on top... too hard to get to