Race Headers for a Dakota

Thinking about building a Gen2 Dakota to go racing. Would be a stoked SB. Are there any race headers available for these? I am thinking 1 7/8 tubes.

I had Hooker on my 94 with 1 7/8 primaries.

If you are looking to stroke a 5.2, let me know. I have a set of forged Diamond pistons and Eagle I beam rods for sale.

The only thing I see listed for a Dakota from Hooker is 1 5/8 primaries. I have a stroker engine with Edelbrock heads may change to Indy 360-2 heads. I just thought a Dakota would be easy to do for racing. You certainly can acquire on in good shape a lot cheaper than a older Mopar.

Whoops..my bad...meant 1 5/8 inch...sorry..

You did not say if this would be a Magnum or LA based motor but here are a couple of links for you. I've been doing a little research on building a 95 Dakota around my 422" W2 motor.

http://www.truedualexhaust.com/

http://www.dakota-durango.com/forum/forumdisplay.php?f=127

Mike Gray

Dang I wish someone made a stainless 1 3/4 or 1 5/8 shorty. I can find steel, but not stainless.

I wonder if I could use a mid length for my turbo app??? Anyone make those sizes in stainless? I see steel...

I was looking to put an LA motor in it. This would be race only so I am not opposed making some room in the engine compartment.