Question Lokar locking dipstick P/N 1211441 ???

Just put in this Lokar locking dipstick nice peice. Now I wished I had room for the low dallor dipstick but that never happens for me just have to spend all my $$$ on useless stuff. Any way the question I have (were should be the full mark be?) The bottom of the dipstick is 1.035 from the end of the tube or 1/4 higher than the valve body base to the transmisson and the full mark would be 1" higher than that. Or maybe someone can give me a measurement from the factory dipstick
Thanks

Nobody knows?

From what I know the fluid level is just below the
pan mounting surface... you'll have to measure from
there

Thanks, looks like they made the cable too short no problem I'll just add a little section

Just some Info incase someone else tries the Lokar locking tranny dipstick. Found my old stock 727 tube and measured off of that. The lokar was short by 1.358" over servicing my transmission by that much wouldn’t have been good.