Posted By: Badfish67
Window net installation pictures - 01/22/10 06:41 PM
Anyone have any pictures or can take a picture of their window net installation? I just got a RJS #999 net and the angle of the net is not the same angle as my cage so I would like to see how you guys mounted yours.
Thanks
Posted By: Anonymous
Re: Window net installation pictures - 01/22/10 08:20 PM
heres mine, a little tab locks it in on the side bar with a lower rod.
Posted By: Sixpak
Re: Window net installation pictures - 01/22/10 10:14 PM
I bent the bottom rod just past where it slips thru the front of the net at a 30 degree angle or so til it intersected with the door bar, and then bent it straight again parallel to the door bar so that the rod would line up and slide into the weld on bushing on the door bar. IIRC I had to buy a longer rod to do this, but they are available at any Home Depot or similar center. For the back of the bottom rod I welded the bushing to the main bar that goes across the main hoop.
Posted By: barracudabob
Re: Window net installation pictures - 01/23/10 01:03 AM
Does it matter if they're on the inside or the outside of the cage? Thanks, Bob
Posted By: Anonymous
Post deleted by Defbob - 01/23/10 02:00 AM
Posted By: Anonymous
Post deleted by Defbob - 01/23/10 02:58 AM
Posted By: Badfish67
Re: Window net installation pictures - 01/23/10 03:53 AM
What company makes a custom size window net?
Posted By: Bigbeep
Re: Window net installation pictures - 01/23/10 06:58 AM
Stroud will make you a custom net, but I bet their angled net will fit fine. I went through this exact same thing when building my car. I looked at the measurements they have and ordered one. It was almost a perfect match to my cage/door bar.
www.stroudsafety.com Hope this helps.Beep