Posted By: JoWeTu_6
Spray bar valve covers - 10/30/09 12:24 AM
Ok I'm building my owen spray bar valve covers.
Can anyone tell me what size is the bulkhead fitting is it a -4 or -3 and what size are the lines under the covers?
Posted By: Bob_Coomer
Re: Spray bar valve covers - 10/30/09 03:57 AM
I made mine out of 3/16 brake lines using all inverted flares or 1/8th NPT stuff. The holes were with a 1/16 drill bit or in the .060-.070 range.
Sorry No pics.
Posted By: JoWeTu_6
Re: Spray bar valve covers - 10/31/09 03:35 AM
thanx Bpb that is what I need, It's down hill now.
John T.
Posted By: Tobbe
Re: Spray bar valve covers - 10/31/09 05:40 AM
here are an old tread whit picīs
spraybars
Posted By: JoWeTu_6
Re: Spray bar valve covers - 10/31/09 02:57 PM
Thanx: Tobbe great pic's just what the doctor ordered.
John T.
Posted By: HardcoreB
Re: Spray bar valve covers - 11/01/09 02:09 AM
Your probably well into making some now but, Indy uses a -3AN tee in each cover and further reduces oil flow by adding a jet/orifice, .040 was in mine. FWIW you'll probably get a better end product making your own. One suggestion I have is to verify the spray location before you rely on it.(Via oil priming.)
Posted By: JoWeTu_6
Re: Spray bar valve covers - 11/01/09 12:01 PM
Thanx HardcoreB,
I was not sure -3 or -4 tee's
Thats is very helpful.
I should be good togo now thanx again.
