Need advice on removing wrist pin locks!!!!

I have a set of Wiseco pistons on BME rods and I need to remove the rods. They have the CS25 pin retainers,Retainer Width/Wire Diameter .042.And I am not sure how to remove them. It looks like they are wrapped about 4 rounds. The only way I see to remove them is to take a small screw driver and pry the outer wire out and just unwrap them.

Is this the correct way to remove them? I do not want to ruin them. Thanks

Thats pretty much how I do it... I use a small pick
and wind them out

Thanks MR_P_BODY, was just not sure if that was the right way or not. I bet its a lots harder to get them back in than out. Thanks again

Quote:

---

Thanks MR_P_BODY, was just not sure if that was the right way or not. I bet its a lots harder to get them back in than out. Thanks again

---

Actually they go in fairly easy