Posted By: flatlinedude
Any drop in solid roller lifters for magnum engines? - 08/08/09 01:34 AM
Looking to run maybe a mechanical roller is a mag small block. Looking for a drop in lifter, with pushrod oiling.
Thanks.
Posted By: Brian Hafliger
Re: Any drop in solid roller lifters for magnum engines? - 08/08/09 01:40 AM
My lifters drop right in. Pushrod oil, oil bearings, oil holes are parallel to the axle, all the good stuff!
Posted By: Brian Hafliger
Re: Any drop in solid roller lifters for magnum engines? - 08/08/09 01:45 AM
I sell them for $550.00 plus shipping. Same as the BB lifters.
Posted By: Ron Silva
Re: Any drop in solid roller lifters for magnum engines? - 08/08/09 03:28 PM
Brian, thanks for posting those pics. I think that is the first time I have seen your lifters. You did what I wanted to do a long time ago with the paralell feed hole etc. I talked to Comp a long time ago about doing that. Especially putting the link bars on the front. Those lifters should have been made that way from day one.
Thanks so much, Ron.
Posted By: lowell66dart
Re: Any drop in solid roller lifters for magnum engines? - 08/08/09 04:41 PM
Any one tried these in an R block? I just picked up an NOS block and and need to start mapping out a combo.
Posted By: HotRodDave
Re: Any drop in solid roller lifters for magnum engines? - 08/08/09 04:57 PM
I bet you would have pushrod interfearance with the guide bars if you try them in a 48 degree block
Posted By: lowell66dart
Re: Any drop in solid roller lifters for magnum engines? - 08/08/09 05:00 PM
Forgot to say this is a 59 degree block.