Which intake to try with holley 1050 dominator

If i was to run a Holley non hp 9375 dominator on my 440 dart which intake would you guys recommend. I have a pretty much box stock mopar m1 and a very ported victor 440 intake which are 4150. Or should i get a Team G or a mopar m1 4500 intake. I am running a mopar m1 tunnel ram with 2 750 carters right now. I just want to see how my car would respond to a single carb. also i am trying to see if i am having carb issues with my tunnel ram.even though this is a street car so far it has been more of a race car. please let me know what all info you need? thanks Mopar65

M1 or VICTOR with 2 inch adapter

hi ari440 the victor i have is the one i got off of you. so you say it is a toss up between the 2 intakes i have?? thanks Mopar65

yes

it depends on your combo M1 makes good power at 6500 the victor wants 7000 rpm


this was I tryed out the two manifolds

and they where both with the two inch adapter and 8896 - 1050

It would be the cheapest route to just use the Victor, and a adapter. Im guessing you have hood clearance cause the current combo is a tunnel ram correct?. The Victor is a good piece.
And should make good power. Those old 9375's work well as single four carbs despite what some may say.

thanks guys yes i will be using a 2 inch spacer. I guess i can always bring both to the track with me and try them.so do you think the mopar m1 4500 would be a bad intake to use? I had it on my old 65 Plymouth and ran a bunch of 10.50 1/4 miles with it. but the 65 had a lot better engine than this car does right now.here is a pick of the carb. A moparts member gave me a great deal on it.also yes bob i have a hood scoop that will clear.Thanks Mopar65

The Mopar M1 4500 intake is a good one as is the new Super Victor from Edelbrock.

Quote:

---

new Super Victor from Edelbrock.

---

is this a standrd port or max wedge


how dos it compare it to the victor