I hearby concede to JericoGTX….

Although I tried as hard as I could I could not out number Jeff this weekend. It was a valiant (actually Valiant Duster) effort, but I fell short. I was hoping the SLO-est N/A W8 on the planet would at least run harder than a stick equipped B body with a tractor motor but it was not to be. It was bad enough watching Doug and his show car hit 8’s before me, but then you lay that number down…. I give up… I’m flying the white flag. Nothing but a lowly small block deserving of life in some 5th Avenue hauling g-Ma to bingo.

What were you thinking?

You can't give up now. You've got enough.
Doug

Oh how I'd love to have that 60" Jay.

It's all in fun. Hopefully when you head North, we can line up, have a fun race, and then celebrate the night away with some Grain Belt Nordeast. We might harass each other, but for sure on my end, I have nothing but respect for you, and how your car runs.

Awesome times...all 3 of you! I'd also love to have any of those 60 foots! I have yet to go a 1.2xx.

Well at least I didn’t have to pay for a steak dinner over it!

It’s funny looking back…. I’d never in a million years thought I’d have a bottom 9 sec car. Of course at this stage of the game I kinda wish it was the complete bone stock /6 car it was born as. It is fun to wheel though

MULTIPLE steak dinners at that. LOL!!!

A 5.70 is enouogh to get you and 8....Just sayin

While it is admirable to give the respect where it's due, as has been said by a few you have enough to get there already given the incrementals. I wouldn't concede yet. Was it over when the Germans bombed Peal Harbor?!

Normally I'd say yes, BUT Doug and I both go 120mph in the 1/8. Our time slips are almost identical, and we are covering the back half faster than Jay, where he has us on the front 330'.

A viscous fluid coupling torque multiplying device could get you there

I might as well carry a purse around too, at that point..

And the heels???

……awesome!!

That is true….. most of my 1/4 speeds are 146. Think the best is 147.8.

For comparison these are my 2 best hits 1/8 and 1/4
Doug

Doug and Jeff, if I may ask, what cubic inch are your motors? Thanks!

Mine is 563ci. 4.375 stroke, and 4.524 bore. Doug's is slightly bigger than mine, with a 4.500 stroke, and I think 4.530 bore, but could be wrong. Yes, both quite a bit bigger than Jay's, but neither of us is spinning the motor as high as Jay either.

Thank you!

Mine is the largest and least efficient, 580"@3350lbs
Doug

I wouldn't say that. Mine is 200lbs less, and runs slower.

It would give you a place to carry those clutch adjusting tools you won't need anymore

The disrespect is unreal, lol

I only adjusted the clutch ONCE this year...

How many bags of floor dry did you use for a leaking front pump this year???

Just to clarify, I wasn't throwing stones about being more ci than Jay. For some reason I thought both of you were around 500 inches.

Thanks!