Engine Oil Retention Device……

While doing some small maintenance on the car and oil change I figured I’d snap a few pics of mine since a few people have asked. A buddy of mine built it out of aluminum. It fits perfect and snug underneath with a small gap below the oil pan. It has two holes drilled through the AlterKtion in front and two rear tab-brackets attached to the midplate. When mounted it’s about 1” above the frame-saver skis. Nice clean setup easy to install/remove.

One more

Looks good Wes.

Looks good. I need to make one this winter for my car. Tired of putting my engine diaper on for the strip and taking it back off for the street. Retains too much heat on those extremely hot summer days. Besides melting excess strape material on the headers gets old.

Looks good. We will be in your neck of the woods testing on the 10th with the red car. Be great to see you out there

A little off topic, but, what have you got planned for that PG sitting behind the hoist leg????

Thanks John.

Thanks. I was going to run a custom blanket but chose not to in the end. I’m happy with this setup. Hope I never need it to do its job LOL

Thanks Al. On the calendar. I’ll come check you guys out.

That is a spare Glide I’ve had. It’s now going to find its way into my kids car being built by Comp Chassis.

That Fox Body is on point ! !
Good luck , looks like a top notch ride !!

what if anything are you using to absorb oil ?


Tex

Thanks. It will be nice when it’s done. Mike at Comp Chassis always does an excellent job. Still a ways to go. Motor should be done soon.

Phelps 1” F3 Oil Retaining Felt on the interior of the pan.

Thanks

Tex