Re: MSD ready to run, with rpm heads? - 08/06/2202:39 PM
I have Edelbrock RPM Performer heads on a RB. I had to clearance the head a little with a grinder to get a Holley HyperSpark distributor to fit. I have not had any ill effects from the clearancing. I just took a little at a time until it fit and would rotate. The Hyperspark doesn't have a vacuum advance canister. I seem to remember an adaptor available in the 70's to raise the distributor above the head, but that was a long time ago and CRS.
Re: MSD ready to run, with rpm heads? - 08/07/2207:13 PM
"I seem to remember an adaptor available in the 70's to raise the distributor above the head, but that was a long time ago and CRS."
wasn't that adapter used on B blocks to use the RB distributor ? i remember seeing a blueprint of that adapter somewhere, so that it could be fabbed up by a person out of aluminum bar stock.