switching from 8 3/4 to dana

would the driveshaft length remain the same when doing this swap? I've order an s60 unit to replace my 8 3/4 .

The driveshaft will need to be shortened

Agree , on mine it was about 1.5 " difference if I remember correctly

Good time to step up to a 1350 joint in the front.

well that's not what I wanted to hear. i have a carbon fiber driveshaft.. man this is getting expensive !!! I have the 1350 conversion on my current set up.

You can slide the Dana 60 back a little on leaf springs to make the driveshaft you have fit now but do you want to hurt the weight bias when you do that?
I would rather slide it forward and get a new end put on your driveshaft and shorten it to fit, if that is possible

Just move everything forwards a little bit at a time,keeping the prop AS IS lol

NEVER GO BACK AND NEVER LOOK BACK...