edelbrock victor Jr. CNC porting

Thinking about sending my big block victor Jr. heads off over the winter to have then cnc ported, at Hughes. Has anybody done this with back to back numbers to compare? How much HP or ET did it improve? I am just a poor boy trying to have fun, and I have reached the point with my engine that any thing to make more power is thousands instead of hundreds.

You might check with Brett Miller, I thought he did a set of BB Victors, he might have a program.
I would use Brett before anybody.

Those were small block Victors.
If it was me i would have Modern do the cnc work

He was working on some BB victors, but I think it stalled.

Might want to shoot him a PM

MW or standard-port?

Other engine specs?

The port, or the project?

Sorry, couldn't resist...

http://s1120.photobucket.com/user/d7cook/library/?sort=3&page=1

The pics towards the end are Cnc ported by modern. I haven't had time to migrate them from photo bucket yet. If you're using a mid plate be sure and mill one end of the head. They will stick past the rear face on one side.

Call Bob at Modern cyl head he has a nice program for those heads