Posted By: moparmattkos
Can someone tell what this cam is???? - 03/08/09 07:18 AM
I have a comp cams roller that i cant figure out the cam specs on it. To me there is just way too much writing on the end to tell what it is?? Can someone please help????
Posted By: gremlinsteve
Re: Can someone tell what this cam is???? - 03/08/09 09:13 AM
intake lobe is 4254 that is a lobe rated at 288 @.050 with a .440 lobe lift.
exhaust is a 1494 lobe rated at 304 @.050 with a .440 lobe lift also.
steve
Posted By: CompWedgeEngines
Re: Can someone tell what this cam is???? - 03/08/09 01:11 PM
As Steve says and it looks like a 112 Lobe seperation angle.
Posted By: DemonDust
Re: Can someone tell what this cam is???? - 03/08/09 02:26 PM
Depends what ratio rockers you are using.
Lobe lift x rocker ratio = total valve lift
Posted By: dusturbd340W5
Re: Can someone tell what this cam is???? - 03/08/09 02:26 PM
gross lift would be .660 with a 1.5 and .704 with a 1.6
Posted By: moparmattkos
Re: Can someone tell what this cam is???? - 03/08/09 02:44 PM
I have never had a roller cam before, can i install this on a 110 center line???
Posted By: DemonDust
Re: Can someone tell what this cam is???? - 03/08/09 02:47 PM
You can install it where ever you want
I'd call comp and ask them what they recommend.
Posted By: CompWedgeEngines
Re: Can someone tell what this cam is???? - 03/08/09 05:53 PM
The IC is all based on the spec of the car and combo. You'd most likely be fine at 110, but I am also guessing the cam has 4* advance ground into it. The bottom line is put it where you want it, dont get caught up in anything else other than what IC YOU want. The 4* advance usually gets people all confused. SImply put the cam where you needit to be.