Keith Black gear drives

Would anyone have install instructions for this gear drive setup? In a pdf or printable sheet????
TIA

Sorry I don’t to help you out but I always google stuff like that and always find the info I need. Man I love google

I tried... not getting much though???

i




Do you have the model number

I've used and installed all three brands of BB gear drives, Donovan, Milidon and KB. I don't remember which one uses which pieces to set the back lash, they don't all use the same parts and procedures though
On the Milidon they send you a bigger alignment dowel for replacing the stock ones, you remove the stock ones and use a piece of newspaper cut to fit between all three gears and push the gears up tight so the paper will move when you rotate the crankshaft and camshaft and then tighten down the cover and drill the pin holes out to the size of the new pin and install them, works good That cover has a harden insert press into it that barely fits onto the new dowel also
I don't remember much about the other two
I recently reused the Milidon on a bracket motor I'm building for myself is the only reason I can recall the details on it, I bought the new bigger alignment pins from Milidon last year
I do have the original installation instruction on paper for it also
I wish I knew how to scan and attached it on here, but I don't

I will try and look on it and get it..

The KB gear drive's were made by a company called casale. I have inquired for info on a KB gear drive with a pump drive. If I get info I will share it.

Thanks!

On 2 of my engines I am running a KB gear drive
but both are SB.. on those the idler is on a
ecentric and you use paper as a guide.. love
that set up

I didn't know KB made SB gear drives. Did they have their own cover, or do they fit under the timing cover like a Milodon?

It fits under the stock cover on the SB.. just have
to drill and tap the idler hole

Try this, I believe they are the same.

You the man!!!! Thanks

Here is KB instructions with a pump drive.