Talked to trick flow about new smallblock heads

Plan on buying a set and putting them on a zero deck flattop 418 shortblock i have.
Have an idea of the roller cam i want to run.
They will offer a bolt on ready set of heads that will work perfectly with the cam i have in mind
240/700 pac/ trick flow mechanical roller springs, valves, Ti retainers, cnc, valve job, ready to bolt on and run...... 1099 each the guy told ne
If they make the power i hope they do, they should sell a bunch of them at that price point( will be cheaper for flat tappet setup)
Should be a 12.7 ish compression motor. Cookie cutter. Single plane, 950, 1 7/8 headers, 904, 8 inch convertor. Hoping for real low 10’s at 3250-3300 pounds not leaning on it to hard. 6500 ish shift point, 4.10 gear, 28 tire.
Cam is 259/267 on a 106, 645 gross lift

Sounds like a nice set up will they work with your rocker gear

No.... spring OD is to big
Have to look for rocker gear...... T&D maybe

Comp dual conical springs should work with that cam and should clear any rocker arm.

Did TF have any updates on the release date?

Said September at the worst, hopefully sooner

Man i would love to see you with a G3 in your ride. LOL
Matt