Posted By: Scoober
Turning oil pump on 340 thru distributor hole. - 11/09/17 05:44 AM
Hello All,
I want to fire up my 340 that has been sitting in the garage for a good ten years After changing the oil, I would like to spin over the oil pump before actually firing the engine.
What is the procedure for re-installing the distributor gear, so that the engine ignition timing will be correct? Especially if I turn over the engine in between pumping?
Or should I not turn the engine over until the gear is back in??
Thank you....
I want to fire up my 340 that has been sitting in the garage for a good ten years After changing the oil, I would like to spin over the oil pump before actually firing the engine.
What is the procedure for re-installing the distributor gear, so that the engine ignition timing will be correct? Especially if I turn over the engine in between pumping?
Or should I not turn the engine over until the gear is back in??
Thank you....