MP 90 Degree Oil Filter Mount Gaskets

Does anyone know the correct thicknesses of the gaskets for the MP 90 Degree oil fiter mount?

reportedly the felpro "single' round gasket #70078 is a hair thicker than the single round gasket in the MP 3 piece kit. I have one (not sure which, MP or FP) that I will mike tomorrow. either would (should) work fine for you & a caveat is to clean the recessed block circular recess squeaky clean & to use some cement to hold the gasket in place as you raise the adapter up in place & to have it clocked correctly as you raise it so that you dont have to rotate it after "contact" is made. Leak issue I am assuming? EDIT Oh you needed the thickness of the thick cork one that goes on the big bolt inside the housing and the thin one that goes under the bolt head.

Looks like the thick cork gasket is about .175" thick. The P5249320 kit with all 3 pieces is still available.

Yeah, if you can measure them, that would be great. Thanx Guys!

Steff, Superformance sell the gasket sets for the adapter. I have a couple sets if you need measurements let me know.

I used to have those gaskets in my file cabinet, in 2013...hope you get the dimension needed

Superformance #340-K1

Inner cork & rubber gasket .195"
Outer fiber washer .062"
Large housing gasket .047"

Mine is .089" but I do not know what brand it is.

This kit works GREAT.

I don`t know if you are having a sealing problem or not but make sure the bolt is not too long. I had one that came in the kit that was a little long. It was not allowing me to get the adapter tight enough even though the bolt felt plenty tight.

Thanx Guys! Picked up the Superformance gaskets kit from Marsh Performance today.

Don't know what the reason was behind your original question but if you have any about what you're receiving give me a call.

Thanks for your support STEFF
(and pittsburghracer )

p.s...... if you need to retain the large gasket in the block don't use any adhesives, a couple dabs of grease would do you right.

My Son's Duster was leaking and we didnt want to wait a few days for a new gasket set to be mail ordered from anyone. So, we were just going to cut one out of gasket material. But, luckily Marsh Perf. had some in stock and I was near them today. So, I stopped by and got one. It all worked out. I also picked up a few sets of your carb gaskets too.