Putting on Rons Toilet

OK! trying to get a toilet system fuel system lined out. Everthing ok till I got to this point of trying to figure where to put fuel tank (no room upfront in Dart) since I had fuel cell in back decided to go with surge tank still fighting where to put it. The radiator support has been a problem because this is old race car and folks wittled on it. Friend suggested build whole new support would be ok but thats beyond my ability and would just like to get this thing fired up will think about support this winter. Anyhow decided to put surge tank up where radiator support is passenger side. Did ok rigging up bracket for it now wanting to find small radiator for drivers side for cooling and mounting it(16" x 18") Any ideas or pics of some of your guys set ups?

Here are some pictures of a 67 barracuda that I put an injected small block into. It has a Ron's surge tank cut into the front right hand inner fender well. The radiator is a 30" Ron Davis with electric fan and shroud fitted into the stock hole in the core support to make room for the Steff's dry sump tank. I also cut a primer tank into the left hand inner fender well. It was tight, but it all fit. I hope you can make things out in the pictures.

I don't know how to post pics here, I have ran toilets on a t/r on a sb in my dart since 08, currently run one on a single 4bbl intake, I just had a buddy fab up a 4gal cell. It fits where the batt would have been, with zero cutting.

66er, how fast is that car you posted about. ??

I don't know how fast. We are not finished with it yet. We think that it will be between 8.90 to 8.50. The engine is a 514" W-8. it dynoed at 905 hp. @ 6500 RPM. 800 ft. lb of torque @ 4900. We'll see if he can get it hooked up.

I have mine under the fender. Didn't have much room under the hood

Did have friend rework radiator support and put cell behind right headlight bucket after bracing it in.