need gaskets for my tunnel ram

Posted By: moparbud

need gaskets for my tunnel ram - 01/27/09 03:01 PM

guys where do you get your gaskets for your tunnel ram intakes mine is a mopar performance i need the two that goes under the top half

Posted By: Dragula

Re: need gaskets for my tunnel ram - 01/27/09 03:31 PM

Comes in a blue tube. Says 'RTV' on it or something like that on it.

Posted By: QWK_ENUF

Re: need gaskets for my tunnel ram - 01/27/09 06:09 PM

gasket paper and trimmer

Posted By: Cab_Burge

Re: need gaskets for my tunnel ram - 01/27/09 08:23 PM

Quote:

gasket paper and trimmer

Thats the way I make them, I also use Hylomar as the gasket sealant

Posted By: RodStRace

Re: need gaskets for my tunnel ram - 01/27/09 09:47 PM

When I had mine, I tried to find pre-made. None were found, so I got a thick sheet of material and made my own. The ones I did find for other intakes were more than the sheet anyway...

Posted By: The Shadow

Re: need gaskets for my tunnel ram - 01/27/09 09:59 PM

Quote:

Quote:

gasket paper and trimmer

Thats the way I make them, I also use Hylomar as the gasket sealant

Personally I would just use the Hylomar.

Posted By: RedRam

Re: need gaskets for my tunnel ram - 01/27/09 10:00 PM

Quote:

... so I got a thick sheet of material and made my own...

Same here for my M1 TR.
I also cut my gaskets a little wider than the narrow factory gaskets that got sucked in and caused MAJOR vac leaks.

Posted By: MR_P_BODY

Re: need gaskets for my tunnel ram - 01/27/09 11:56 PM

I havent seen those gaskets since MP quit selling them,
I just make my own

Posted By: tjmarcus1

Re: need gaskets for my tunnel ram - 01/28/09 12:10 AM

what? another tunnel ram freak??? either make'em or use sealer.

Posted By: old_racer

Re: need gaskets for my tunnel ram - 01/28/09 12:38 AM

Hi
fel pro has a nice small roll part no. 3157 just got one at NAPA, it's about .027 thick and 10in. x 26in. nice stuff, I made some hemi intake gaskets out of it.
Russ

Posted By: moparbud

Re: need gaskets for my tunnel ram - 01/28/09 12:46 AM

ok thanks guys i will make them