Anybody have a lead on a 1/4" crank pulley spacer?

I need a good one (offset bolt, proper step/snaps) for my 540 to make the alternator line up. Can't move it w/o major hassle.

Use two of these:

http://arengineering.com/products/crank-pulley-spacer-0-125-thick-zinc-plated/

Two of these should do it

http://store.440source.com/Crank-Pulley-Shim-125-Thickness/productinfo/127-1005/

Good Luck.

If you want the machined step to center the pulley then you'll need to have a machine shop make one from billet. I sell a billet pulley spacer that is 3/8 thick for guys running one of my motor plates, but I don't sell a 1/4 inch stepped version.

I have one with the machined step but it's 1/2" thick. You could have it cut down to 1/4".

2

March Pulley has them, orderable thru Summit I blieve

I just had my machinist make me one. Cost me maybe $15.

Remember that MOPAR has a 2.25 register