Any pump gas B1 motors out there?

I was worndering if anyone on here has built and used a set of B1 heads on pump gas on the street and or on the strip? If so would you mind sharing your combination and results thanks in advance either way

not a pump gas combo

511ci 13.1 comp 277/800 lift B1 heads 1150 dominater

for next year

i have a full pumpgas streetcar

B1 originals, B1 Intake, Venolia 4.5 pistons, Callies 4.77 Crank, 6.8" H beam Rods, Koleno KP440 Block, 1270cfm AED Max Pro Dominator, Crane Mec Roller 320/328deg 114 disp angle int .79 ex .76 CR10.69
TTI 2.0/ 2 1/8 /3.5 Headers

original B1 rockers broke last summer at 800/275 lbs
i will try T&D´s original shaft ones next summer

Quote:

---

i have a full pumpgas streetcar

B1 originals, B1 Intake, Venolia 4.5 pistons, Callies 4.77 Crank, 6.8" H beam Rods, Koleno KP440 Block, 1270cfm AED Max Pro Dominator, Crane Mec Roller 320/328deg 114 disp angle int .79 ex .76 CR10.69
TTI 2.0/ 2 1/8 /3.5 Headers

original B1 rockers broke last summer at 800/275 lbs
i will try T&D´s original shaft ones next summer

---

That is quite a bit bigger C.I. than I'm thinking of building, do you mind sharing your results if you dyno tested or ran it at one of your tracks over there? I hope so Thanks