Posted By: rvw
426 Hemi head stud tool - 11/03/14 04:20 AM
Where can I get the proper crows foot tool to properly torque the head studs on my Hemi. 1/2 inch 12 point nuts
426 Hemi head stud tool
Posted By: Cab_Burge
Re: 426 Hemi head stud tool - 11/03/14 04:28 AM
Snap On, Mac, Proto, Cornwell and others all have them (I have one of each in 5/8, 9/16 and 1/2 inch sizes 
), usually there in 3/8 drive so I use a 3/8 to 1/2 drive adatper and correct (I use the snap On formula) the Ft Lbs. torque specs. for the extension length of the adapters 
), usually there in 3/8 drive so I use a 3/8 to 1/2 drive adatper and correct (I use the snap On formula) the Ft Lbs. torque specs. for the extension length of the adapters
Posted By: rvw
Re: 426 Hemi head stud tool - 11/03/14 04:32 AM
I have a set but they are all 6 point I need 12 point.
Posted By: Cab_Burge
Re: 426 Hemi head stud tool - 11/03/14 04:40 AM
Mine are all 12 point
Posted By: Hemi Allstate
Re: 426 Hemi head stud tool - 11/03/14 04:51 AM
I bought a 12 point from Snap On.
Mark
Posted By: Hemi Allstate
Re: 426 Hemi head stud tool - 11/03/14 04:20 PM
Quote:
Where can I get the proper crows foot tool to properly torque the head studs on my Hemi. 1/2 inch 12 point nuts
Snap On # FRDH161
Mark
Posted By: Challenger 1
Re: 426 Hemi head stud tool - 11/03/14 05:35 PM
I just torque em by hand, have never used a torque wrench on them. And I have removed and reinstalled hemi heads over a 100 times easy in the last 15 years.