Moparts

holley carb flooding after a pass

Posted By: mopartuner

holley carb flooding after a pass - 09/08/13 02:02 AM

After a run the car doesn't want to run it is flooded.is this from the vent tubes leeking into the carb?I checked the floats and are ok
Posted By: SpareParts

Re: holley carb flooding after a pass - 09/08/13 02:28 AM

I would pull the needle and seat out and see if any debris made it in and is sticking it. The rubber O ring can deteriorate and get lodged in there.
Posted By: QTR MILR

Re: holley carb flooding after a pass - 09/08/13 10:21 AM

Quote:

I would pull the needle and seat out and see if any debris made it in and is sticking it. The rubber O ring can deteriorate and get lodged in there.



I agree.. I've had that issue before. Also if you still have power valves in it check them out too...
Posted By: dOOc

Re: holley carb flooding after a pass - 09/08/13 11:20 AM

A bad float will do this also .....sunken or leaking
Posted By: oldtimer5151

Re: holley carb flooding after a pass - 09/08/13 06:43 PM

Make sure you have the two plastic anti pull over tubes in the metering plates.
© 2024 Moparts Forums