Posted By: Ian
pick a cam - 07/09/13 04:01 PM
hi , building a new short for my junk 408 top end is 1050 indy 230 cnc comp will be 13.5 h beams steel crank current roller is 254/262 050 650 lift with 1.6 on 107 l/c with 11.4 comp 1 3/4 pipes ,what cam and pipes should i go to
Posted By: Ian
Re: pick a cam - 07/10/13 05:38 PM
no one has any thoughts on what i should go to in cam and pipes
Posted By: Dodgem
Re: pick a cam - 07/10/13 07:40 PM
I'm not sure there is a better cam for your car?
But what is the weight
tranny gearing
rear gearing
tire size
heads and flow
and so on??
Posted By: emarine01
Re: pick a cam - 07/11/13 02:22 AM
..... 270/276...... 685+ lift..... 109 in @ 105, 1 7/8 pipe to 3.5 collector.....
Posted By: MR_P_BODY
Re: pick a cam - 07/11/13 02:22 AM
What do you plan on turning for rpm... but as a guess
I would say 1 7/8 pri with 3 1/2 collector without
knowing alot of stuff of your engine
Posted By: Thumperdart
Re: pick a cam - 07/11/13 04:53 AM
That`s a baby cam duration wise...........where do the heads flow best to lift wise? I`m the "bigger is better" guy when cams are involved.
Posted By: Ian
Re: pick a cam - 07/11/13 05:41 AM
max rpm 7200 ,converter is 4400 now asp with current combo , i spin it to 7600 on the gas now the new short should raise the stall to 4800 the heads stall at 700 ,i run twin 3 inch pipes with a x pipe , i was thinking of 1 7/8 pipes too, cam in the high 260 s low 270s range thanks
Posted By: CRIKEY
Re: pick a cam - 07/11/13 05:58 AM
Nitrous converter but not a nitrous cam??