pics of the new bullet

pics of the new bullet - 12/20/12 02:30 AM

Here are some pics of my new engine. It is a 454 low deck stroker based of a 400 block that has been zero decked and filled. It has Eagle rods, Eagle crank, Ross pistons, and a Milodon oil system. it has Stealth heads that have been ported, polished, and milled to make the chambers 62 cc's. It has an Eddy Victor 383 intake that was also ported and an alky Dominator. Full roller. Going into a 225" dragster. Any ET guesses?

Posted By: poisondart2

Re: pics of the new bullet - 12/20/12 02:45 AM

8.40@159

Posted By: Mopar dragster

Re: pics of the new bullet - 12/20/12 02:50 AM

Quote:

[Email]8.40@159[/Email]

Running eighth mile, but I like where your heads at.

Posted By: poisondart2

Re: pics of the new bullet - 12/20/12 03:02 AM

OK 5.34@125 ? Hardtail?

Posted By: jamesc

Re: pics of the new bullet - 12/20/12 03:07 AM

depending on the weight of the car it should run O's or teens at >160 in the 1/4 or 5teens in the 1/8

Posted By: Mopar dragster

Re: pics of the new bullet - 12/20/12 03:13 AM

Quote:

OK [Email]5.34@125[/Email] ? Hardtail?

Swingarm suspended car. My mind says it will run 5.0's. my gut says 5.teens. Just so it's consistent I,really don't care though.

Posted By: poisondart2

Re: pics of the new bullet - 12/20/12 03:20 AM

So it's around 1600LBS ? 550HP ?

Posted By: Mopar dragster

Re: pics of the new bullet - 12/20/12 03:33 AM

Quote:

So it's around 1600LBS ? 550HP ?

Weight should be close. HP should be in between 550 and 600, but who knows.

Posted By: jamesc

Re: pics of the new bullet - 12/20/12 03:34 AM

Quote:

So it's around 1600LBS ? 550HP ?

i would think it's heavier and should have 650ish minimum. if it's not real heavy and runs good 5.0s isn't out of the question

Posted By: jamesc

Re: pics of the new bullet - 12/20/12 03:36 AM

1600# suspended car is pretty lite u ever weigh it? don't know much about the heads but if that engine doesn't make >600 somethings wrong with it

Posted By: poisondart2

Re: pics of the new bullet - 12/20/12 03:43 AM

Quote:

Quote:

So it's around 1600LBS ? 550HP ?

i would think it's heavier and should have 650ish minimum. if it's not real heavy and runs good 5.0s isn't out of the question

Yeah I dont see 650 ? But I figured it was going to be light. 650ish I dont know about ? But if it does a fun ride for sure

Posted By: Mopar dragster

Re: pics of the new bullet - 12/20/12 03:43 AM

All guesses on my part. Never weighed it. I will when final assembly is complete. Just hope it's consistent if nothing else. It is built to not be hard on parts hopefully. .650 roller cam so it's not too,aggressive.

Quote:

1600# suspended car is pretty lite u ever weigh it? don't know much about the heads but if that engine doesn't make >600 somethings wrong with it

Posted By: poisondart2

Re: pics of the new bullet - 12/20/12 03:55 AM

Did your brother build it ? Lets see a photo

Posted By: Mopar dragster

Re: pics of the new bullet - 12/20/12 04:01 AM

Most recent pics I have. It is on the ground now being wired. Tommy Mauney built the car originally. My brother put the swing arm suspension on the back and updated the chassis.

Quote:

Did your brother build it ? Lets see a photo

Posted By: poisondart2

Re: pics of the new bullet - 12/20/12 04:16 AM

Looks Great

Can you loan me your brother?

Posted By: jamesc

Re: pics of the new bullet - 12/20/12 02:54 PM

650 might be a little on the high side but i would expect >600 for sure. the engine in my car is similar 451, eheads, 11.5:1 cr, hp950 on gas, m1 single plane, 275�/.575ft cam. you have more cam, cr, carb and on alky those things should make more hp for sure. last time i weighed my car it was around 1575 without driver. some things have changed but the weight should be close. i figure minimum of 1750-1800 on the starting line and it regularly runs 160 which i figure would equate to around 600hp