440+ .045 OVER-BORE HEAD GASKETS???

Posted By: Labratt

440+ .045 OVER-BORE HEAD GASKETS??? - 07/26/12 11:09 PM

Can I get opinions on a good set of head gaskets for my 11-11.25:1,cnc-ported Eddy RPM's...with a bore size of 4.365? Mostly street driven,with a few trips to the track every year!..except this one!

Thanks in advance!

Randy B.

Attached picture 7309071-GTXBACKHOME!!!002.jpg

Posted By: mopar65

Re: 440+ .045 OVER-BORE HEAD GASKETS??? - 07/27/12 12:07 AM

Quote:

Can I get opinions on a good set of head gaskets for my 11-11.25:1,cnc-ported Eddy RPM's...with a bore size of 4.365? Mostly street driven,with a few trips to the track every year!..except this one! Thanks in advance! Randy B.

hey randy how have you been? me OK trying not to melt from all the heat.I am using the felpro 8519 gaskets on my 11.1.1 indy ez head 440 that i race on 93 pump gas.that is what Dewayne told me to run. oh my 440 is 0.030 over. Mopar65

Posted By: 451Mopar

Re: 440+ .045 OVER-BORE HEAD GASKETS??? - 07/27/12 08:01 AM

These are 4.375 MLS 0.040" thick from Mr Gasket.
Pretty much a copy of the Cometic gaskets at a lower price.
http://www.summitracing.com/parts/MRG-3217G/

Posted By: CompWedgeEngines

Re: 440+ .045 OVER-BORE HEAD GASKETS??? - 07/27/12 04:58 PM

Randy

Check your email...

Thanks

Todd

Posted By: Labratt

Re: 440+ .045 OVER-BORE HEAD GASKETS??? - 07/27/12 09:39 PM

Thanks,guys!

Hey,Bobby!

...try to not melt! It's been HOT everywhere this Summer! Record days reaching 90 or above,here in the Detroit area!

Thanks for the advice,ALL of you! Dwayne is definately one of my "go-to-guys"!!!

Sounds like the 8519 will do just fine! Todd,from Competition Wedge,calculated the CR to be 10.87:1. Should be fine on pump gas!

Randy B.