BB Motor Plates

Who's motor plates are you using? Looking for both, front and mid plate.
Thank you

ANDY,F

MANCINI sells them

S&W and then I add the alternator...

I just got a BB plate in today from S&W for a customers
car
EDIT
The mid plate is a Competition Engineering one .090 thick

andys all the way. i beleive the mid was competition eng.

Just make sure you get one that will work for the car. If it is in a stock chassis you will need one that has enough meat for the offset. Just my

I have the Comp Engineering front plate on mine. The added thickness of some plates is not necessary.

The car is getting a front half done to it. It will all be round tube with struts. Does that make a difference in which one would work?

thanks

Just have to make sure they are wide enough to fit
your chassis rails... most likely you will need 36"
widths but that will depend on your chassis set up...
make sure you put the front mounting tabs behind the
motor plate so its easier to get the engine in

I have both Competition Eng front & mid plates on my Challenger. I had to extend the passenger side several inches to make it fit for the offset. All in all both fit great though.