Posted By: Scamp408
Race Car Stance (opinions needed) - 04/01/12 06:01 PM
Pic with out jack is 0 height with jack is +1. I can decide.
Quote:
0 or -1
I like them low.
Quote:Me too. A little nose down at the big end is always a good thing.
I like the first pic which is 0. Ron
Quote:
Also... when you showed the back up... were you lifting
it on the rear end... didnt really see an difference
in the tire to wheel well
Quote:Quote:
Also... when you showed the back up... were you lifting
it on the rear end... didnt really see an difference
in the tire to wheel well
I jacked up the from the tank/trunk well area and measured 1in difference on the lip .
Quote:
0...I like a little tuck...not in the weeds, but not stick bug...
What size you got on the back?
With the stock width axle, I just have to jack up by the body to slide the tires off
Quote:Quote:Quote:
Also... when you showed the back up... were you lifting
it on the rear end... didnt really see an difference
in the tire to wheel well
I jacked up the from the tank/trunk well area and measured 1in difference on the lip .
ok... wasnt sure if I seen a difference
Quote:
I like the fastest time slip, try it both ways and see Can you fit the 315x60x15 on your car
Quote:
How about -1? I like them low, never cared for the jacked up in the back look.
Quote:
Lower definately looks better. Keep that butt outta the breeze.
Quote:
I like the first pic which is 0. Ron
Quote:
My worth!!
Quote:
Not to sound dumb or ignorant but what are you using to raise it and lower it??? Can ya post a pic??
I like it either at 0 or -1 NICE car by the way!!!!!
Quote:MOPAR -> Mostly Old People And Rednecks
the back end raised up reminds me of.....