Does any one know of a source for this /6 to NP-435 brace?

A pal is looking for one of these (marked with the red XXXXs) does anyone know of a source for this brace?

Thanks!

hello Alaska , that brace is listed in the mopar parts books under section 6-09-11 and they call it a " Trans Housing to Cylinder Block Strut" part # 2468197 new , but just go get one out of a pick a part or junkyard . Ronnie

I have one from a /6 to a 833OD..probably the same. PM me if he still needs it.

Thanks.

The 833 version is different though, that has already been ruled out.

Ronher's auto parts in Wilmer, MN had a slant six np 435 combo laying in the dirt by the dodge trucks a year ago. Do the slant 6 and small block share the same bellhousing. I was thinking about a 5.7 swap in my truck. I would need to change my 12 inch hydraulic bell to a 11 inch so i could find a flywheel.

/6 bell is different.

Interested in that brace though!

58pwrwgn thanks for the tip!

I was able to get that one, but.......

It is not the right one either.

Does anyone else happen to know how or where to find one?