5.2 magnum heads

What is the best cylinder heads for 2000 dodge ram 5.2 magnum new castings ?

These have been used in MoPar Action articles. http://www.aamidwest.com/enginequest/eq-cylinder-heads/chrysler-magnum-head/

casting material? cost?

best would be Magnum Edelbrock Aluminum heads, or something from Indy that's designed to use the pedistal rockers and oil through pushrods.

but those will also be expensive. The edelbrocks will support 500 crank hp out of the box, but will run you $1600

EQ heads are a good choice, and can be opened up with port work to make some serious power, but they are iron which weighs more and you'll have to pay attention to compression. a decent set of unported heads will run you $800, but as soon as you start porting, you're looking at $1500-2000.

It will be a stockrebuild i know the stock heads crack mine did passenger side only any other options. thanks eric

If its just a generic stock rebuild then consider having hardened seats pressed in by a competent machine shop. Cost will probably be less than buying new heads and having them set up.

Otherwise, you could look at the EQ heads. New castings that are better than the production heads.

No new valve seats fixing drivers side head leaked anit frezz into cyl eq the only one some head companies say new castings but give no casting # in the ad thanks again

Procomp china castings are available,better but not needed for a stock rebuild are the EQ's. Another option is to do a VJ on the cracked stockers and go unless it's spitting water. LOL

Yes head is cracked any one use or deal with odessa cyl head company i am in c.t any one closer i found. them on ebay. thanks for the help

I got my EQs from Clearwater Cylinder in Florida. Not sure that is any closer.
Craig

Quote:

---

I got my EQs from Clearwater Cylinder in Florida. Not sure that is any closer.
Craig

---

Same company.