Posted By: Prince_Valiant
D-Series small block headers....UPDATE - 06/11/13 12:33 AM
Does anyone produce either stepped 1 5/8th to 1 3/4 headers, or simply just 1 3/4 inch headers for small block 72-80 D series 2wd pick-ups?
What are the fast small block D-series running for exhaust?
UPDATED below.
Posted By: 76dodgeboy
Re: D-Series small block headers.... - 06/11/13 12:56 AM
This header question is asked about once a month. I think somebody said tti makes some. Otherwise if you build them you have what you want
Posted By: BulletBob
Re: D-Series small block headers.... - 06/12/13 05:17 AM
Hedman used to sell a step header for our trucks I've had a couple sets over the years.
I'd get a set for an E body & move one tube
I had to notch the bottom lip on the frame at the prop valve to clear
They fit up inside the framerails & won't drag on a lowered truck
I used Hookers they were like $600 my cost
Posted By: theraif
Re: D-Series small block headers.... - 06/13/13 08:39 AM
its the lucas oil racing series
Posted By: Prince_Valiant
Re: D-Series small block headers....UPDATE - 06/13/13 04:32 PM
*Update*
So the latest is this:
TTI headers can be made to fit...
Waiting on an answer of what will fit best though...A Body or B body. If one does not come, then the shop I'll be working with will get a set of both and we'll just figure it out. Sure, it'll probably involve a couple notches or denting here or there, but it'll give me the exact header I want (stepped) without the cost of getting a custom made job.
Have to do it via the shop because I'd hate to try w/o a lift and every assortment of tools...
So hopefully in a couple of months, we can know a bit better what works.
Also I've been told that hooker 5115's can work too (B/E body headers, 1 3/4 primary tubing, 3" collector. I'd be inclined to try however, the flange isn't as thick, and I think for this engine, a stepped header will actually perform best.
Posted By: JDMopar
Re: D-Series small block headers....UPDATE - 06/14/13 03:22 AM
I had a set of Hedman Tork Step headers on my 84 D350 2WD. It was a 360 truck, and the headers were for a 4WD frame, but fit with VERY minor clearancing on the passenger side frame rail. They were some of the nicest headers I've ever had.