Ebody convertible wheel house-where to cut !!

Hey Guys,

Does anyone have a factory bulletin/template or specs of the measurements on where to cut the wheelhouses before fitting the convertible "caps" on them...

Thanks,
Shawn

I used the old ones as my template once I separated the cap from the wheel house.

Check out these guys... http://www.musclecarrestorations.com/

they have a cuda that they did it to with good picks.

Al

Quote:

---

I used the old ones as my template once I separated the cap from the wheel house.

Check out these guys... http://www.musclecarrestorations.com/

they have a cuda that they did it to with good picks.

Al

---

Thanks for the post Al, I can do that if needed without a problem, but I was hopeing someone had original specs handy for the procedure to save some time... the customer is going to be into enough hours as it is already... and his originals had been butchered by another "restoration" shop, so templating off them would take some time !