Posted By: mopar mike
70 ebody amd quarters ? anybody installed yet? - 05/19/08 05:25 PM
just trying to see if the amd quarters fit any better than the junk goodmarks? anybody tryed both? 70 cuda thanks moparts
Quote:
I know what ya mean there... I had to pull the ds in to fit up with the filler panel and then it got a little bow in the roof area I had to fix... was alot of work to get right.
Quote:
Mines already done, just didn't expect one to go on fine and not need much then the other need a good bit of work. Still better than patch panels, but wish they fit a little better!
Quote:Quote:
Mines already done, just didn't expect one to go on fine and not need much then the other need a good bit of work. Still better than patch panels, but wish they fit a little better!
Just curious 70Chally was it the right side that went on with out much work? Clonedcuda and I just test fit the right quarter on his project and it seemed to fit fairly well to me, but then again I'm used to the junk we used to have to chop up and beat into submission.
Thanks
Bob
Quote:
The right side definetly fit better. And this car had bit hit some on that side, so was suprised it did fit so well.
Like the post above says, don't expect to just install them, weld right up and be done. They need alot, not sure they are worth it over the patch style panels are not. I prefer to keep as much of the original metal as I can. Leave the gaps, etc... factory.
Quote:
Since when are the Goodmarks junk??
Quote:
I weighed them for you.They weight is the same with in a pound of each other . However I did a NOS cuda rear pan and it is 12 pounds and goodmark pan is 7 pounds.The oem 1/4 is 25 and the other is 25 both weighed with trunk gutter and filler to the rear tail panel. So it just show's that if the tooling would have been finished we could have had one of the most needed mind blowing parts in the mopar hobbie. JAYCUDA