2 Quick questions so I can put my dash back in...

I am getting ready to put my dash back in my Challenger and I have two quick questions:

1) Do I have the wires in this picture in the right place? Most of the wires are hard to screw up since the connectors only go one way or the dash is marked, but thest two can easily go to either location.

What is supposed to hook to this connector over by the glovebox?

The wires on the A/C switch are interchangable.. I believe the plug above the glove box plugs into the blower resistor on the heater box..

BTW that little black box behind the gloce box is a seatbelt buzzer very irritating..

The wires that go to the heater resistor are actually the ones that are hanging there just to the outside of dash frame. I think that the connector has something to do with the seatbelt buzzer system since the wire colors are the same? Is there another harness that runs to the seats from the passenger side or just on the drivers side? The car is a 73 Challenger BTW but I am not sure what the harness came out of - it came with a rallye gauge setup I bought. Everything else has matched up pretty well so far, but I would really like to put this dang dash in and want to be sure all wiring is accounted for before I do.

How about the always irritating "Key In" buzzer... Bolt the dash in, you know the connector is there & can deal with it as needed.. Move forward..