Moparts

Decal locations for A-12 road runner

Posted By: moparo

Decal locations for A-12 road runner - 07/29/09 11:23 AM

Can someone post the locations of the Road Runner emblems on the doors, and trunk lid. I also need the locations for the birds on the door and the location for the decal on the hood scoop.
Thanks
Posted By: RoadRunnerJD

Re: Decal locations for A-12 road runner - 07/30/09 12:43 AM

I guess nobody is going to answer this? Door birds about 5/8" in front of the name with spinning legs (wheels) centered on emblem. Trunk bird centered over lock in middle of recessed area. Hood decal very near the front, centered vertically. Why not ask on the A12 forum and you'll probably get a factory photo of the hood decal?

Attached picture 5384563-CopyofDoorbird.JPG
Posted By: RoadRunnerJD

Re: Decal locations for A-12 road runner - 07/30/09 12:45 AM

Hood

Attached picture 5384568-Hood3(Medium).jpg
Posted By: goalsetterpk

Re: Decal locations for A-12 road runner - 10/04/10 04:50 PM

I used OEM Satellite doors on my 1969 Rusty Roadrunner.

Can anyone please post measurements from front of 'road runner' emblem to edge of door, and also measurement from top of body line down to top of 'road runner' emblem?

This will also help the folks buying the new AMD door shells. THANKS MOPARTS!
Posted By: RoadRunner

Re: Decal locations for A-12 road runner - 10/04/10 05:45 PM

Quote:

I used OEM Satellite doors on my 1969 Rusty Roadrunner.

Can anyone please post measurements from front of 'road runner' emblem to edge of door, and also measurement from top of body line down to top of 'road runner' emblem?

This will also help the folks buying the new AMD door shells. THANKS MOPARTS!




I took these off a rusty door at a swap meet. I used a piece of paper and follded it about 1" along the edge and rested the edge on the upper crease body line of the door.



Door, passenger,14.25 first hole
11-9/16 third hole,8-11/16 last
4-13/16 down first hole
4-7/8 down last hole

If I recall, this gets you three of the four holes, the last one should be pretty simple to figure out based on the emblem.

I used a Vis-a-vis marker to mark the holes. That is a marker used for overhead projectors that markes very well on smooth painted surfaces, but comes of with water.
Posted By: goalsetterpk

Re: Decal locations for A-12 road runner - 10/09/10 02:28 AM

THANKS I'm using sticky emblems, too chicken to drill holes but your dimensions are perfect Thanks Again.
© 2024 Moparts Forums