1970 Dart Swinger Bumble Bee Stripe

Trying find the placement for the Bumble Bee stripe, ie. the distance from the bumper, fender edge,to the start of the stripe......thanks

The side marker light opening should determine where it goes I'm guessing.

The stipes I installed werent cut for the marker lights. I can try and post a picture later however Im having computer issues. If you put them up to the car you should be able to get them pretty close anyways. Start with the sides then do the lid last.

So you have to go back and trim around the lights with an x-acto blade? Why don't they just pre-cut the holes in the first place?

Thanks Guys,went back to the shop and placed them on the car.Used the body line on the rear of the fender as a guide.Thank you for your response,,,,Dartwizer

Here's mine, but can't swear that's correct.

Here is how we did my sons 72 Dart. I looked at alot of darts and it looked that the stripe was about as wide as the side marker and went right over the marker light and was even with the light. Ron