Posted By: AARCONV
71 cuda shaker 340 hardware - 03/20/19 01:31 AM
What is the correct hardware from the carburetor stud on up to mount the base plate and air filter assy to the carburetor..I never really had the correct stuff..just got away with a threaded rod and 2 wing nuts
Posted By: 71vert340
Re: 71 cuda shaker 340 hardware - 03/20/19 04:31 PM
Maybe a few photos of mine can help.
Terry
.jpg "20150310_190657 (Medium).jpg")
.jpg "20150310_190212 (Small).jpg")
.jpg "20150310_191439 (Medium).jpg")
Posted By: 71vert340
Re: 71 cuda shaker 340 hardware - 03/20/19 04:35 PM
One more. I've got others. If you need something more, let me know.
Terry
.jpg "20150310_191352 (Medium).jpg")
Posted By: 76orangewagon
Re: 71 cuda shaker 340 hardware - 03/21/19 11:48 AM
The one I have for my 71 340 shaker set up is 6 1/16" in length and I bought it from Bill Rolik Enterprises.
Posted By: AARCONV
Re: 71 cuda shaker 340 hardware - 03/21/19 07:13 PM
I see the rod has a smooth shank and i see there is a washer under the 1 wing nut...I always had 2 wing nuts, 1 to hold the base plate down 1st. but then again this was the same since I bought the car in 1977. Thanks
Posted By: 71vert340
Re: 71 cuda shaker 340 hardware - 03/22/19 04:40 AM
The parts I have shown in my photos are what were on the car when I purchased it 6/1972. It is possible they were changed by the original owner before I got the car. I believe I changed the factory air filter when I first got it. Thanks.
Terry