Cuda Go-wing install

I'm installing a go-wing on a 70 Cuda. I need the measurements for where I need to drill the 4 holes. Does any buddy got them? Thanks.

Just looked at the online Year One catalog and they still show the hole measurements on page 567.

Here's the YO info along with a factory print covering 70-1 Cuda and Challenger, and a pic of what your 70 Cuda trunk lid underside should look like, hope this helps?

Mike

mounting the under trunk brackets will be spot on for the 4 holes I would think

Thank you!

Need to cut the trunk on my 70RR. Have the templates... what do folks use to make the cuts.... I am scared....lol

i would trace the template out, then use a unibit [if there is room] to get close to the radius size of the corners.
then use a wizz wheel to connect the dots.
get close, then finish the cutout with a small flap wheel.
just my thoughts on how i would do this, i'm not an expert, so keep that in mind.

Thanks! wizz wheel?

Small air powered/electric cut off/dremel wheel...

Thanks! Have one for dremel!