Posted By: hulmule
1972 Cuda restoration questions - 08/16/18 04:26 AM
The car is a 72 Cuda , 340 3 speed . Had factory duals with cut outs.Right now the car is on the rotisserie.Would like some inputs plus a question.
My friend noticed that an exhaust hanger was missing on the passenger side before it goes over the axles on the rear upper floor board. It was never there from factory. He feels it should be and added one on his car. Anyone ever seen this ? There's one on the drivers side from factory.
Noticed center support for roof is pulled away from roof. Do i fill gap between or cut out and raise to meet roof and reweld in ??
I welded in torque boxes and frame ties.Going to layout for vinyl top trim cause of new quarters were installed.Pretty much ready to ship to my painter friend and start getting ready for paint. So while in this stage anything else i should look at?
My friend noticed that an exhaust hanger was missing on the passenger side before it goes over the axles on the rear upper floor board. It was never there from factory. He feels it should be and added one on his car. Anyone ever seen this ? There's one on the drivers side from factory.
Noticed center support for roof is pulled away from roof. Do i fill gap between or cut out and raise to meet roof and reweld in ??
I welded in torque boxes and frame ties.Going to layout for vinyl top trim cause of new quarters were installed.Pretty much ready to ship to my painter friend and start getting ready for paint. So while in this stage anything else i should look at?