71 Cuda p/s pump

I'm converting my 71 cuda 340 from manual to power steering. car is 340 4-speed with a 3.55 gear. what is the correct p/s pump saginaw or chrysler federal? I'm sure it is suppose to have a cooler also with the gear ratio. Thanks.

federal w/cooler

Thanks for the info.

Also see the thread at https://board.moparts.org/ubbthreads/ubbthreads.php/topics/2330597/aar-p-s-pump.html#Post2330597 since the pulleys are not all the same.

I've found that 71 340 E-bodies with T/A gears typically have federal pumps with solid pulleys. The earlier cars with the standard ratio I have seen Saginaw pumps more than not.

Below is a picture of the pulley from my 340 71 cuda with 3/31 SPD

What rear differential ratio?

This is the pulley that is on my AAR.

The federal pump with the T/A gear is a 3.23 Open

Any recommendations for a correct looking power steering hose? 340 w/Federal pump.

I ended up buying an nos one of ebay. I have not seen any reproductions that even come near correct. I checked ebay everyday until one came up.

What did that NOS hose cost you.

$175 on a buy it now.