Door panel attachment clips..?

Is there a diagram anywhere that shows the correct orientation for door panel clips? Since I dont have the old ones...???? 70 RR

There are several rectangular pockets in the back of the door panel and the clips fit in those pockets. Hard to miss orient them. You have to move them around a little bit to be sure the clips align with the holes in the door as you push them in one at a time. Take it slow or you might make bumps that show once they are installed.

Yea... rectangular pockets you have to cut out on new panel.. but they can go one of 2 ways.. just wondering if there was a diagram or anything.. I can figure it out...

Here's a passenger side from a '70 Bee should be the same. Clips push in opposite the arrow in cutouts. I took detailed pics can post them later if these aren't clear.

Front edge and lower corner

Middle bottom

Rear bottom and back edge. I have the back seat panels if you need pics.

Boy Thanks!! I cant see arrows.. probably my old eyes... can you send me hi res pics..? I will IM you email address
KV

Here's the passenger side rear panel. I augmented the cutout arrow with black marker to show direction clip slides in. Worst comes to worst I can send the entire set to you. I won't be using these, I need to get a set of blue ones.

Ok let's see if these are readable. I augmented with marker the passengers side door. Front and middle section:

And the back

That works!! Perfect. Thankyou!!!

No Problemo. What brand panels did you get? I need a set and was going to get them from Legendary.

Where I got mine! Really nicely made. Will post a pic when I get them installed