AMD 67-69 barracuda quarter panel fitment

How is the fitment of the 67-69 AMD full quarters?

I installed a pair on a 69 Barracuda fastback. They were excellent. Great gaps and straight surfaces. Very pleased.
I also used the AMD trunk extensions and AMD rear valance which also were great.
Now if we could just convince AMD to make 67-69 Barracuda fenders.....

I sell AMD but this is not a sell on them over good mark but I need to say this. Do not buy the good mark skins. I have a 67 notch back in the shop. Only needed drop offs and lower 1/4's like up about 6 inches. We couldn't pull the trigger to buy the full amd ones even at our cost for that small of amount needed. So we bought a set of skins. They were about 1/4" to long where we cut them in. The body lines were no were near as sharp as should be. We made our patches fit but if I would of had to use the skins I'd thrown them away. Like I said it's not a sales pitch on amd but incase you get the idea to buy good mark on cost I'd say change your mind fast!

Thanks for the hands-on and honest comments here.

I've never read/heard comments on the 67-69 Cuda quarters. Great info to put in the mental filling cabinet.

Great thanks.. will need 1 outer wheel house 1 floor extension and1 rear panel as well.

Bought some of the first ones. Fit up great

Are the trunk floor extensions the same for fastbacks and notchbacks?

Yes they are

Second on the A-Body Barracuda fenders! GOOD fenders are just not out there anymore. Took me two years to find a good one, and the cost was unreal!