Posted By: seeker
UNI_BODY SUPPORT OR NO - 08/29/14 01:10 PM
getting ready to replace entire floor in a 66 Charger, is the body stiff enough to do so without support from floor or cross braces in door frames ? Want to do on rotisserie if safe, thanks for any advice :-)
Posted By: flypaper
Re: UNI_BODY SUPPORT OR NO - 08/29/14 02:43 PM
you should be ok without supports for a floor pan.
some people will overkill and do it anyway
Posted By: Stanton
Re: UNI_BODY SUPPORT OR NO - 08/30/14 04:52 AM
I wouldn't do a floor on a rotisserie, there's no point, all the welds should be done inside the car.
Last full floor I did on a rotisserie was a 67 GTX, and it worked out fine. With solid rockers you should be safe
Posted By: astjp2
Re: UNI_BODY SUPPORT OR NO - 09/07/14 01:33 AM
Mine was done on the rotisserie, you can tip it on the side, stand up and spot weld it in place through the door.