Posted By: FJR doc
Brushed Trim Ring Question - 02/26/14 02:14 PM
My 1970 Duster 340 has Rallye 14 inch wheels with brushed trim rings. I would like to run 15 inch Rallye wheels on the back for a more aggressive stance. Does anybody make a 15 inch trim ring that has a close appearance to the 14 inch factory ring?
Posted By: Anonymous
Re: Brushed Trim Ring Question - 02/26/14 02:33 PM
Pretty sure the 15" trim rings were all polished and not brushed.
Posted By: FJR doc
Re: Brushed Trim Ring Question - 02/26/14 03:07 PM
I like the look of the brushed rings. If that's the case, I suppose I could try to duplicate the finish with fine sandpaper or some other abrasive.
Posted By: LimeliteAero
Re: Brushed Trim Ring Question - 02/26/14 03:42 PM
It seems I stick my foot in my mouth too often, but here goes.
15 trim rings were brushed in 71.
Posted By: 71birdJ68
Re: Brushed Trim Ring Question - 02/26/14 04:13 PM
Take your foot back out of your mouth. They were brushed for 71. To the OP, nobody makes the correct brushed ring. The outer lip is polished, so like you said the only thing you can do is sand it. What I'm going to do is tape off the lip, and put the ring on an old wheel mounted on the rear axle, then with around 400 sandpaper spin the wheel and sand the ring. The ring that are brushed look like it was done with 80 grit, just trash.
Posted By: AdamR
Re: Brushed Trim Ring Question - 02/26/14 04:17 PM
400 may be a bit harsh. I would try red scotch brite first. If that didnt work I would try some 600 wet.
Posted By: FJR doc
Re: Brushed Trim Ring Question - 02/26/14 04:27 PM
Which polished 15 inch trim ring has the closest profile and best fit to an original?
Posted By: can.al
Re: Brushed Trim Ring Question - 02/26/14 04:40 PM
..i thought red scotch brite was 400?
Posted By: moparfan53
Re: Brushed Trim Ring Question - 02/26/14 07:49 PM
Specialty ring on the left. On the right another aftermarket ring I was considering due to being less money.
Posted By: MCTPhoenix
Re: Brushed Trim Ring Question - 02/27/14 11:14 PM
I went thru this a few months ago after ordering 15x7 rallies from Summit. I tried the polished and brushed rings and sent them back. I even tried an expensive set from year one and sent them back. The closest to original I found in terms of the fit and finish on the lip came from a place called LMC Truck
http://www.lmctruck.com/icatalog/cc/full.aspx?Page=107 See 38-3777 for the set of four @ $89
Posted By: 1MYTGTX
Re: Brushed Trim Ring Question - 02/28/14 02:07 AM
I got a set of brushed 15" rings from Summit Racing...$25 each I believe...
Posted By: 1MYTGTX
Re: Brushed Trim Ring Question - 02/28/14 02:08 AM
These replaced the polished rings I originally got from Specialty Wheels along with he 15" Road Wheels